|
Pic below is with a after market bumper
Not long after dropping motor in, still trying to plan out how it'll all fit, and how to run oil/ water lines, etc
this photo would have been taken after the rx was made legall, would have clocked 2-3000 mile in her by now
Below, the first time she moved under 20b power
Std Cosmo IC, which has been mod. so the pipes into & out of th IC go past the Radiator, instead of over the
top of the Radiator.
New Bar and Plate IC, more trimming need on the front bumper, made the hole wider than IC, so air can clean air can get
to the Radiator.
This wastegate (38mm) will go on with this "B' series 20b, But it will be with a different set of twin turbo's
(will still use the Std twin turbos wastegate as well as this 38mm WG) this will get done alone with the bigger
Intercooler with new pipe work, Bigger Radiator, Bigger Exhaust, Fuel Pump & lines, and other mod's
Below, The 6 Ib flywheel
The Clutch, 6 pluck, brass button
The next four photos show the difference between the 20b trottle body and a series 4 RX7 13bt trottle body.
13brew motor--
|
